To Next Page

To Previous Page

First-time setup

Set up the computer

To set up the computer, you will

1. Insert the battery into the computer.

2. Connect the computer to external power.

✎

The battery begins to charge.

3. Turn on the computer.

4. Set up the software.

5. Create recovery discs (recommended).

✎

Refer to Appendix C, “Backup and recovery,” for

instructions.

CAUTION: To prevent file corruption and to ensure that the correct drivers

are installed:

■� Do not set up the computer for the first time while the computer is

docked in an optional docking device.

■� During the hardware and software setup procedures:

❏� Do not unplug the computer from external power.

❏� Do not shut down the computer or initiate standby or

hibernation.

Getting Started� 1–3

Other manuals for HP Compaq NX7400

Questions and Answers:

Need help?

Do you have a question about the HP Compaq NX7400 and is the answer not in the manual?

General