Compaq Professional Workstation SP750 Hardware Reference Guide 2-27
Compaq Confidential - Need to Know Required
Writer: Beth Zanca Part Number: 190709-001 File Name: ch2.doc
Last Saved On: 04/12/00 1:02 PM Last Saved By: Lydia Sanchez
Installing an Expansion Board
To install a PCI expansion board:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the workstation access panel and locate the correct vacant
slot in the workstation chassis.
3. Remove the screw securing the expansion slot cover, then remove
the slot cover, as illustrated.
To replace an expansion slot cover, reverse the above procedure.
Removing the screw and expansion slot cover
To Next Page
Loading...
