2-19
R Class System Memory Upgrade
Memory Installation Procedure
L. Replace the Top
Sheet Metal Panels
1. Position the hinge tab of the top rear panel so that it goes into the slot at the rear
of the system cabinet. Lower the top rear panel into place.
2. Position the hinge tab of the top front panel so that it goes into the slot at the
front of the system cabinet. Lower the top front panel into place.
3. Align and tighten the three screws of the top front panel into the holes as shown
in the illustration.
This completes the system memory upgrade installation procedure. Proceed to the
Memory Upgrade Verification procedure starting on the next page.
To Next Page
Loading...
