HP dc7900 series

8. Press the two release tabs on the inside of the bezel towards the right side of the computer (1) and
rotate the bezel off from right to left (2).
Figure 2-5 Removing the Front Bezel
9. Replace the fan shroud.
To replace the front bezel:
1. Slide the hooks on the left side of the bezel into the slots on the chassis (1) then press the right
side of the bezel onto the chassis so that the latches snap in place (2).
Figure 2-6 Replacing the Front Bezel
2. Replace the access panel.
3. If the computer was on a stand, replace the stand.
12 Chapter 2 Hardware Upgrades ENWW