Continuable and Non-Continuable Error Codes 95
System Error Codes
• Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. foam from the
printer’s packaging, screws, plastic parts, etc...) restricting the movement of the Service Station.
• If the System Error continues, replace the Service Station ⇒ Page 364.
SE Code: 21:13 - Problem in the Service Station
Problem Description:
Problem with the Service Station.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. screws, plastic
parts, etc...) restricting the movement of the Service Station.
• Switch the Power OFF from the back of the Printer, remove the Printhead Maintenance Cartridge,
and switch on.
• If the System Error continues, replace the Service Station ⇒ Page 364.
SE Code: 23:10 - Problem with pressurization in the APS
Problem Description:
The APS has received a request to depressurize, but the system does not depressurize in under a specific
time (120 seconds).
Corrective Action:
• Check that the relief valve cable is not damaged and is correctly connected to the PrintMech PCA.
• Check the continuity in the cable of the relief valve.
• Try tapping the relief valve of the APS with a screw driver to release the mechanism.
• Check the air tubes connected to the relief valve are not bent or twisted and that air can flow in the
tubes.
• To check if the issue has been solved perform the APS service test ⇒
Page 146.
• If the test fails replace the APS ⇒
Page 395.
• R
eplace the PrintMech PCA
⇒
Page 464.
• R
eplace the
Sausalito PCI
PCA
⇒
Page 444.
SE Code: 24:03 - Ink Seup Failure
Problem Description:
Ink Setup failure. The purge process has failed or has been canceled by the customer.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Try purging the Ink Supply Tubes again when the Printer has been rebooted. If the printer does not
automatically go into the purge process, use the service test procedure “1.4.1 Purge tubes” ⇒
Page 190.
To Next Page
Loading...