106 Chapter 3 System Error Codes
System Error Codes
• Replace the Sausalito PCA ⇒ Page 444
• Replace the cable between the Sausalito and the OMAS Controller Board.
SE Code: 50:11 - Media navigation problem
Problem Description:
Navigation problems, caused by a mis-positioned sensor, DOF or skew issue.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Printer has the latest Firmware version, if not, update the firmware to the latest
version.
• Check that the OMAS Module cable is not damaged and is correctly connected to the OMAS
Controller PCA.
• Replace the OMAS Controller Card ⇒ Page 437
• Replace the OMAS Module ⇒ Page 424
SE Code: 50:14 - Firmware version mis-match
Problem Description:
FW version mismatch between the controller fw and the version of the file in the Engine disk.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Printer has the latest Firmware version, if not, update the firmware to the latest
version.
• Replace the OMAS Controller Card ⇒ Page 437
SE Code: 50.02:10 - Problem with OMAS Controller PCA
Problem Description:
Error with the media advance sensor controller board.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Printer has the latest Firmware version, if not, update the firmware to the latest
version.
• Check that the CAN cable and the Encoder Cable are correctly connected to the OMAS PCA and
the Sausalito PCA.
• Check the connection between the OMAS PCA and the Sausalito PCA (the Sausalito is the card
connected just behind the OMAS PCA).
• Check that the OMAS Module cable is not damaged and is correctly connected to the OMAS
Controller PCA.
• Replace the OMAS Controller Card ⇒ Page 437.
To Next Page
Loading...