Continuable and Non-Continuable Error Codes 107
System Error Codes
SE Code: 51:10 - An error has been detected with the Window Lock Sensor
Problem Description:
Error detected with the sensor on the Window.
Corrective Action:
• Check that the Window Sensor cable is not damaged and is correctly connected to the Interconnect
PCA.
• Check the Window sensor locks are activating the Window Lock Sensor.
• Replace the Left and Right Window Lock Sensor ⇒ page 345 & page 347.
SE Code: 51.01:10 - Problem with the Service Station door sensor
Problem Description:
Error detected with the sensor on the Service Station Door.
Corrective Action:
• Check that the Printhead Maintenance Cartridge Door Sensor
cable is not damaged and is correctly
connected to the Interconnect PCA
.
• Perform the Sensors service test ⇒ Page 173.
• Replace the Printhead Maintenance Cartridge Door Sensor ⇒ Page 554.
SE Code: 52:01 - A problem with the Drop Detector
Problem Description:
Drop Detector fiber detected.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Ink Funnel is correctly installed. Use the ‘Replace Ink Funnel’ process to access the
funnel.
• Check that there is no obstructions in the funnel, such as media which would block the detector
signal.
• Replace the Drop Detector ⇒ Page 377.
SE Code: 52:10 - A problem with the On/Off switch in the Drop Detector
Problem Description:
Drop Detector switch On/Off failure.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the
Drop Detector cable is not damaged and is correctly connected to the Service Station
cable
.
• Check that the
Service Station cable is not damaged and is correctly connected to the Interconnect
PCA
.
To Next Page
Loading...