Service Tests 125
Tests, Utilities & Calibrations
7. The Printer will start the CDS and the following information will be displayed on the Front Panel:
• Starting CDS.
If there is a failure at this point, the Front Panel will display system error code 79:03 ⇒ page 113.
8. The printer will then check the Serial Number and Part Number and display the information on the
Front Panel. Press any key to continue the test:
If the Serial Number does not have assigned a correct 10 character format or the Part number does
not have assigned a correct 6 character format, a fail message will display on the Front Panel. In this
case, re-enter in to the Service Tests submenu and use the diagnostic ‘2.8 Error 71:19 Recovery’ to set
the correct Serial Number (refer to page 132).
9. A message will display on the Front Panel asking whether you want to check the Sausalito. Select
Yes and press OK. This action could take up to 10 minutes.
10. The Printer checks the Sausalito PCI PCA and the following messages will be displayed on the Front
Panel:
• Starting CDS
• Checking Sausalito PCI.
• Starting Sausalito.
• Checking Impact memory
• Checking Gauntlet memory.
If there is a failure at this point, the Front Panel will display system error code 01.0:10 ⇒ page 78.
11. A message will display on the Front Panel asking whether you would like to check the Power Supply.
Select Yes and press OK to confirm your selection.
12. The Printer will check various electrical subsystem, if there is an error at any time, use the information
on chapter 3 ⇒ page 73, to solve the issue.
To Next Page
Loading...