Service Tests 147
Tests, Utilities & Calibrations
3. A message will display on the Front Panel asking you to insert all the Ink Cartridges. Insert all the Ink
Cartridges and press any key to continue:
4. The Front Panel will display the various electrical subsystems being initialized in order to perform the
procedure, if there is a failure at this point the Front Panel will display a system error, troubleshoot
the system error using Chapter 3: System Error codes
⇒
page 73.
5. The Printer will pressurize the APS and the Front Panel will display the following message:
6. The Printer will hold the pressure in the APS and the Front Panel will display the following message:
7. The Printer will pressurize the APS and the Front Panel will display the following message:
If there is a failure starting the Pump, the Front Panel will display a system error code. For more
information on troubleshooting this error code refer to the system errors section
⇒
page 73.
8. Once the test is completed, OK will be displayed on the Front Panel.
To Next Page
Loading...