150 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
5. The following message is displayed on the Front Panel, use the up and down keys to select “Yes“ and
press “Ok“.
6. The following message is displayed on the Front Panel, use the up and down keys to select “Yes“ and
press “Ok“.
7. The following message is displayed on the Front Panel.
Air is now pumping through the air tubes system, pushing any ink that may be there from the Air
tubes into the Dummy Ink Cartridge with the two holes at the top. When this is finished press any key
to continue.
8. The following message is displayed on the Front Panel.
9. Remove the dummy ink cartridge with the two holes and insert it into the other slots that may also
have ink in their air tubes, press “OK“ to continue removing ink from the other air tubes.
When you are sure there is no more ink from the broken bag blocking any of the air tubes, select
“Cancel“.
To Next Page
Loading...