Service Tests 151
Tests, Utilities & Calibrations
10. The following message is displayed on the Front Panel, press any key to finish.
4.4.2 Refill Ink Tubes
Description
The procedures and menu selections must always be performed if a broken bag has been detected by the
printer. In this procedure the printer forces ink from the ink tube that had the broken bag, removing air
bubbles, into a syringe.
Procedure
1. Remove all the dummy Ink Cartridges and install the normal Ink Cartridges.
2. Go to Diagnostic test>4. Ink System Menu>4.3 Broken Bag Recovery Menu>4.4.2 Refill Ink Tubes,
and press OK.
3. The Front Panel will display the various electrical subsystems being initialized in order to perform the
procedure, if there is a failure at this point the Front Panel will display a system error, troubleshoot
the system error using Chapter 3: System Error codes.
4. The following message is displayed on the Front Panel, using the up and down keys, select the color
of the Ink Cartridge that had the broken bag, and press ”OK”.
5. The following message is displayed on the Front Panel, press ”OK”.
CAUTION: This procedure must only be performed after performing the procedure “4.4.3
Recover Broken Bag”
NOTE: It is important that the Ink Cartridge with the broken bag, is discarded and replaced
with a new Ink Cartridge. DO NOT reinstall the Ink Cartridge with the broken bag.
To Next Page
Loading...