Service Menu 183
Tests, Utilities & Calibrations
3. Press OK to change the bootmode. Press Cancel to make no changes and to exit.
1.0 . 2 Fo r c e n o r m a l M o d e
Description
This selection must be made after you no longer want the printer to boot in diagnostic mode. After this
selection is made the printer will boot as normal. This feature is also included in the Diagnostic Menu.
Procedure
1. Go to Service Test Menu >1.0 Boot Mode Menu>1.0.2 Force Normal Mode.
2. The printer asks you to confirm.
3. Press ok to change to the boot mode.
1.1 R e p o r t Te s t s Ve r s i o n
Description
The Report Tests Version displays the firmware and service menu version on the Front Panel. The format
of this version number is GF_03_01_01_XX where XX = service menu version.
Procedure
1. Go to Service Test Menu >1.1 Boot Mode Menu.
2. The printer displays the service menu version.
To Next Page
Loading...