222 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
10. Once the Right Scan-Axis Offset has been calculated the Front Panel prompts you use the Up/
Down keys to move the carriage until the LEFT
edge of the Right Alignment Mark is correctly
aligned with the Primer Positioning Indicator and press ENTER.
11. Use the Up and Down keys to move the Carriage until the LEFT edge of the Right Alignment Mark
is correctly aligned with the Primer Positioning Indicator and press ENTER.
NOTE: To more easily detect the exact position while aligning the Carriage to the Primer it is
a good idea to lightly press down on the Primer while you are moving the Carriage.
To Next Page
Loading...