42 Chapter 2 Troubleshooting
Troubleshooting
Checking the take-up reel is correctly installed
Many system error codes are displayed as a result of the take-up reel not being installed correctly or
because parts have moved or become dislodged from their correct positions. This troubleshooting
procedure checks the mechanical installation of the take-up reel.
1. Check that the take-up reel sensor unit is correctly installed on the right foot.
2. To correctly install the foot, the wheel has to be positioned as shown.
3. Check the cables linking the sensors to the take-up reel Motor Assembly are correctly connected.
4. Check that the take-up reel motor assembly is correctly connected to the rear of the printer.
To Next Page
Loading...