Preventive Maintenance 605
Preventive Maintenance
2. Unlock and open the printer window and apply a few drops of oil (bottle of oil can be found in the
Maintenance Kit) to the pads on either side of the Carriage Assembly.
3. Apply a few drops of oil directly to the Slider Rod on either side of the Carriage Assembly.
4. Press Ok when the lubrication procedure has finished.
5. Clean the substrate jam reflector using a lint-free cloth dampened with distilled water. If you find
dried ink that you cannot remove, try using a lint-free cloth dampened with Methyl Acetate.
6. Press Ok when the jam reflector has been cleaned.
7. Close and lock the Printer Window
Scheduled Maintenance
In some segments of the printer market, the customer tends to print more than the maximum number of
prints that the throughput allows, exceeding by far the limit of the design. When this happens the customer
runs into print quality problems and continuous Printer failures.
The purpose of scheduled preventive maintenance is to avoid these failures - ensuring a good performance
during all the product life.
Level of Printer Usage
Normal printer use means 6,000,000 Carriage Cycles (which corresponds to approximately 100,000
A0 prints on average). Under normal usage conditions, it will be approximately 5 years before the printer
needs maintenance. If the printer is used more than the normal usage conditions, then it will need
maintenance service much more frequently.
To Next Page
Loading...