80 Chapter 3 System Error Codes
System Error Codes
SE Code: 05.3:10 - Main memory size failure
Problem Description:
This is a service test failure and will only be displayed while in the process of testing a part.
Corrective Action:
• Check that at least 256 megabytes of memory is installed in the Printer.
• Check that the Memory Module is installed correctly.
• Try installing the Memory Module in the other Memory slot and check if the system error is still
displayed.
• If the System Error reappears, r
eplace
the Memory Module ⇒ Page 448.
• If the System Error does NOT reappear, then the original slot could be faulty. In this case, replace
the Main PCA ⇒ Page 450
SE Code: 06.03 - NVM file has a bad CRC
Problem Description:
NVM file has a bad CRC.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• If the System Error continues, replace the Hard Disk Drive ⇒ Page 452.
SE Code: 06:10 - Main NVM failure
Problem Description:
Main NVM failure - not detected, read/write failed or readback error.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• If the System Error continues, replace the Hard Disk Drive ⇒ Page 452.
SE Code: 08:11 - Connection problem with the Front Panel
Problem Description:
Problem with communication between the Front Panel, the Formatter and the HDD.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• If the printer emits one or multiple ’beeps’ as the printer turns On, perform the procedure ’Using the
buzzer at Power-up to Troubleshoot’ ⇒Page 43. Four beeps would indicate an error with the Front
Panel:
• Check that the Front Panel cable is not damaged and is correctly connected to the Front Panel
and to the Interconnect PCA.
• Check that the Memory Module is installed correctly.
To Next Page
Loading...