Preview copies and scans
You can preview your copies and scans before committing them to the printer or
file system. With previewing you can:
●
Make image adjustments that are relevant for your selected Original Type,
such as brightness and sharpening, and view the effects of these on your
screen.
●
Visually set the Scan Area (input size) using handles to drag and position a
Scan Area frame on the image.
●
Zoom in and out to evaluate specific image areas and the effects of your
settings.
Load a preview scan or copy
1. Load your original and press the Preview Before Scan/Copy button to turn
preview mode to On.
2. Press the Scan or Copy button to load the preview.
3.
You can at any time press the Cancel button
to close the preview.
Set and preview image adjustments
1.
Press the Adjustment button
at the top left corner of the preview screen.
2. Make your settings in the adjustments dialog.
3. Press the OK button to close the adjustments dialog and see the effects of
your settings on the preview. Use the zoom tools to inspect details and areas
of interest.
4. Repeat steps 1–3 if you need to readjust your settings.
NOTE: The effects of the image adjustment settings are applied and displayed in
the low-resolution preview and hence do not fully represent the final image in the
destination file or printed copy.
ENWW
Preview copies and scans
15
Basic operations
Learning Products Barcelona - Hewlett-Packard Company
To Next Page
Loading...