Set and preview the scan area
The preview shows the image inside a white frame. The frame represents the
current Scan Area (input) size. Changing the frame’s size before scanning will
change the Scan Area settings. The frame's size can be adjusted by moving its
borders and corners. To do so you can:
●
Drag the resize handles
on the frame’s sides and corners.
●
Press with your finger on the place where you wish to reposition the nearest
border edge or corner. The border will jump to that place.
●
Use the image zoom and positioning tools to assist you in setting the frame
size and positioning the image inside of it. The image zoom and positioning
tools are:
Zoom crop: Snaps to the image as cropped by the borders.
Zoom in: Enlarge the image size in the preview. Zooming is targeted on
the center of the window.
Zoom out: Reduce the image size in the preview. Zooming is targeted on
the center of the window.
Zoom all: Displays the whole capture area without cropping. The borders
positions are defined by the current Original size setting.
Image panning tools: Use these arrows to center the captured image
in the window.
Frame center handle (blue circle): Use this to drag the whole size frame
and reposition it on the captured image.
Press the Start Scan/Copy button
when you are finished previewing and want
to commit the job.
Press the Cancel button
if you want to abort the preview process without
committing the job.
16 Chapter 2 Basic operations ENWW
Basic operations
Learning Products Barcelona - Hewlett-Packard Company
To Next Page
Loading...