HP DesignJet T730

I
ntroductory In
f
ormatio
n
4
English
Enable email printing
 Make sure that your printer is correctly connected to the Internet.
 (QDEOH:HE6HUYLFHVGXULQJLQLWLDOVHWXSRIWKHSULQWHURUODWHUE\SUHVVLQJ RQWKHKRPHVFUHHQDQGIROORZLQJWKH
LQVWUXFWLRQVRQWKHIURQWSDQHO7KHSULQWHUPD\QHHGWRUHVWDUWLILWKDVXSGDWHGLWVILUPZDUH
 7KLVLVDQRSWLRQDOVWHSActivate your account by clicking the activation link that you will receive by email. If you don’t
see the message, remember to check your junk email folder.
 This is an optional step: If you are the printer administrator, log in at the HP&RQQHFWHG (http://www.hpFRQQHFWHGFRP
WRFXVWRPL]H\RXUSULQWHUoVHPDLODGGUHVVRUPDQDJHWKHSULQWHUVVHFXULW\IRUUHPRWHSULQWLQJ
Congratulations, you now have completed Web Services setup. HP ePrint is ready to use.
For the latest information, support, and terms of use of the HP &RQQHFWHGsee http://www.hFRQQHFWHGFRP&KHFN
\RXUUHJLRQoVDYDLODELOLW\
<RXFDQDOVREHQHILWIURPDXWRPDWLFILUPZDUHXSGDWHVDIWHUIROORZLQJWKLVVHWXS
Front-panel error messages
If you see an error message that does not appear here, and you are in doubt about the correct response, or if the
recommended action does not seem to solve the problem, try restarting the printer. If the problem remains, contact HP
Support.
Message or code Recommendation
[Color] cartridge is very low on ink Ensure that you have a new cartridge of the same color
ready.
Depleted cartridges must be replaced to resume printing Replace the cartridges as needed.
One or more cartridges appear to be missing or damaged Insert cartridges of the correct color as needed.
Paper jam See the User’s Guide or follow front panel instructions.
Paper width is smaller than the minimum size supported
by the selected paper source. Load cancelled.
Remove the paper and load paper of the correct size.
Loaded paper is too wide. Manual unload required. Remove the paper manually and load paper of the correct
size.
Paper too far from lateral load line. Please try again. Remove and reload the paper.
Please manually unload roll paper and try again. Rewind the roll manually.
Single sheet is loaded with too much skew. Press Eject to
unload paper.
Remove and reload the paper.
The current job has been cancelled because the roll is out
of paper. Load the roll and send the job again.
Load a new roll.
You are printing a multipage job. Load another sheet to
continue printing or cancel the job.
Load another single sheet.
Multi-sheet tray is out of paper. Load paper in multi-sheet
tray and press OK to continue printing or cancel the job.
Load paper into the multi-sheet tray.
End of roll has been reached. It is not possible to load the
roll.
Load a new roll.
Missing or failed printhead Remove and reinsert the same printhead, or try cleaning
the electrical connections. If necessary, insert a new
printhead.
5HƬOOHGRUGHSOHWHGFDUWULGJHGHWHFWHG Check the cartridge.