After printing, the paper has wrinkles or there is too much ink
This happens when too much ink is used. To use less ink, select a thinner category. Matte paper categories
from thinnest to thickest are:
●
Plain Paper
●
Coated Paper
●
Heavyweight Coated Paper
For other image quality problems, see Troubleshooting print-quality issues on page 135.
The printer printed on the wrong paper type
If the printer prints your job before you were able to load your desired paper, you may have Any selected for
the Paper Type in the printer driver. When Any is selected the printer will print immediately on whichever
paper is loaded. Load your desired paper, see Paper handling on page 33, and select your paper type
specically in the driver.
●
In the Windows driver dialog: select the Paper/Quality tab, then select your paper type from the Paper
Type list.
●
In the Mac OS X Print dialog: select the Paper/Quality panel, then select your paper type from the
Paper Type list.
NOTE: Any is the driver default.
Paper mismatch
If the paper currently loaded in the printer is not suitable for a particular job, the printer stops and waits for
you to decide what to do. There are several ways in which the loaded paper may be considered unsuitable:
●
The paper type is not as specied for the job.
●
The paper source (roll, multi-sheet tray, or manual feed) is not as specied for the job.
●
The paper size is smaller than specied for the job.
If you do not specify these things for a particular job, the printer will print on whatever paper is loaded.
If the printer stops for a paper mismatch, you can decide among the following alternatives:
●
Load the correct paper and resume printing.
●
Print the job on the already-loaded paper. The print may be clipped if the paper is not large enough.
●
Cancel the job.
The roll has jammed
When a paper jam occurs, you normally see a message about it in the front-panel display.
If your printer is a T830 MFP
1. Open the roll cover.
ENWW The printer printed on the wrong paper type 123
To Next Page
Loading...
