1. Make sure that your printer is correctly connected to the Internet.
2. Enable Web Services during initial setup of the printer, or later by swiping down the dashboard, touching
and scrolling down and touching Web Services. During the process you will have access to an
Automatic rmware update Service. It is strongly recommended that you have this service enabled and
that you have the unit updated with the latest rmware available to ensure the best performance
possible.
3. This is an optional step: If you are the printer administrator, log in at HP Connected
(http://www.hpconnected.com) to customize your printer’s email address or manage printer security for
remote printing.
Congratulations, you now have completed Web Services setup and HP ePrint is ready to use.
For the latest information, support, and terms of use of HP Connected, see http://www.hpconnected.com
(check your regions's availability).
ENWW Set up Web Services 25
To Next Page
Loading...
