3. Adjust the output tray extensions depending on the length of the paper.
4. Load sheets of paper into the tray with the printed side facing outwards. Ensure that the sheets are all
of the same size.
5. Adjust the tray to t the width of the paper.
View information about the paper
To view the loaded paper information, touch the icon of the active paper source.
The following information is displayed on the front panel:
●
Paper type you have selected
●
Roll or sheet status
●
Width of the paper in millimeters (estimated)
If no roll or no single-sheet paper is loaded, or there is no paper in the multi sheet tray, the message Status:
Not ready and Out of paper is displayed.
Maintain paper
To maintain paper quality, follow the recommendations below.
ENWW View information about the paper 41
To Next Page
Loading...
