HP DesignJet T730

●
Display Name is displayed in the front panel when you are choosing the scan destination. It may be
dierent from the network or FTP folder name.
●
Network Path should contain the network name of the remote computer.
The server and folder names are used to connect to the shared folder by building a network folder
path as follows: \\server name\folder name
For a Network Path, enter the name or IP address of the remote computer and the name of the
shared folder.
Select Next to continue.
8. Dene Log-in Authentication settings.
●
User name should contain the name of the 'scanner user'.
●
Password should contain the password of the 'scanner user'.
Type the user name and password of the 'scanner user' that you have already created on the remote
computer. Leave the user domain eld empty unless the user is a member of a Windows domain. If the
user is only a local user of the remote computer, leave the eld empty. You can use the name (instead of
the IP address) in the server name eld only if the shared folder is on a Windows computer in the same
local network. This must be a simple name (up to 16 characters long) without a domain suix (without
any dots in the name). Fully qualied DNS domain names are not supported. If the product and the
network folder are in dierent networks, or if the remote computer is not running Windows, then you
must use the IPv4 address instead of the name of the remote computer. On IPv6 networks the IPv6
address is also supported.
Select Next to continue.
9. Dene the Setup Conguration for les scanned to the network folder.
NOTE: The scan settings dened for a folder, are exclusive for the setup folder.
ENWW Scan options setup process 65