EasyManuals Logo

HP Designjet Z5200 - PostScript Printer Using

HP Designjet Z5200 - PostScript Printer
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Choose which connection method to use
The following methods can be used to connect your printer.
Connection type Speed Cable length Other factors
Gigabit Ethernet Very fast; varies
according to network
traffic
Long: 100 m (328 ft) Requires extra equipment (switches)
Jetdirect print server
(optional accessory)
Moderate; varies
according to network
traffic
Long: 100 m (328 ft) Requires extra equipment (switches)
Provides additional features
See
http://www.hp.com/go/jetdirect/ for
more details
USB 2.0 Very fast Short: 5 m (16 ft)
NOTE: The speed of any network connection depends on all components used in the network,
which can include network interface cards, hubs, routers, switches and cables. If any one of these
components cannot operate at high speed, you will have a low-speed connection. The speed of your
network connection can also be affected by the total amount of traffic from other devices on the
network.
Connect to a network (Windows)
Before you begin, check your equipment:
The printer should be set up and on.
The Ethernet hub or router should be on and functioning correctly.
All computers on the network should be on and connected to the network.
The printer should be connected to the network.
Now you can proceed to install the printer software and connect your printer:
1. Make a note of the IP address from the status screen on the printer's front panel (192.168.1.1 in
this example):
2. Insert the HP Start-up Kit CD into your computer. If the CD does not start automatically, run the
autorun.exe program in the root folder of the CD.
3. Click Software Installation.
4. Click Express Network Install. The PCL3 printer driver and the HP Utility will be installed.
10 Chapter 2 Installing the software ENWW
Software installation

Other manuals for HP Designjet Z5200 - PostScript Printer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Designjet Z5200 - PostScript Printer and is the answer not in the manual?

HP Designjet Z5200 - PostScript Printer Specifications

General IconGeneral
Print TechnologyThermal Inkjet
Number of Inks8
Memory32 GB (virtual)
Hard Disk160 GB
Line Accuracy+/- 0.1%
Maximum Print Resolution2400 x 1200 dpi
Ink ColorsCyan, Magenta, Yellow, Light Cyan, Light Magenta, Light Gray
Media Sizes SupportedUp to 44 inches wide
ConnectivityGigabit Ethernet (1000Base-T), Hi-Speed USB 2.0
Minimum Line Width0.02 mm
Maximum Optical Density (Black)2.5
Media TypesBond and coated paper, photographic paper, self-adhesive and banner
Media Sizes Standard (Sheets)A4, A3, A2, A1, A0
Media Sizes Standard (Rolls)24 to 44-in rolls
Media ThicknessUp to 0.8 mm
Connectivity, StandardGigabit Ethernet (1000Base-T); Hi-Speed USB 2.0 certified; EIO Jetdirect accessory slot
Print LanguagesAdobe PostScript 3, Adobe PDF 1.7, TIFF, JPEG, HP-GL/2, HP-RTL, CALS G4
Ink TypesPigment-based
Operating Temperature Range5 to 40°C
Dimensions (W x D x H)1770 x 721 x 1050 mm

Related product manuals