HP Designjet Z5200 - PostScript Printer Using

Configure network settings
To configure the network settings from the HP Utility for Windows, select Settings tab > Network
Settings. From the HP Utility for Mac OS, select Network Settings in the Configuration group. You
can view and configure the following network settings.
●
IP Configuration method: specify the way to set an IP address between BOOTP, DHCP, Auto
IP and Manual
●
Host name: specify an IP name for the network device, the name may contain up to 32 ASCII
characters
●
IP address: specify the IP address on the print server, duplicate IP addresses on a TCP/IP
network are not allowed
NOTE: If you change the current IP address and click Apply, the browser loses the current
connection to the print server because it is pointing to the old address. To reconnect, browse to
the new IP address.
●
Subnet mask: specify a subnet mask, which is a 32-bit number applied to an IP address to
determine which bits specify the network and subnet and which bits uniquely specify the node
●
Default gateway: specify the IP address of a router or computer that is used to connect to other
networks or sub-networks, if none exist, use the IP address of the computer or the IP address of
the print server
●
Domain name: specify the name of the DNS domain that the print server resides in, for
example, support.hp.com, note that it does not include the host name; it is not the fully qualified
domain name, such as printer1.support.hp.com
●
Idle timeout: specify the number of seconds that an idle connection is allowed to remain open,
270 is the default value, if set to zero, the timeout is disabled and TCP/IP connections remain
open until closed by the other node (such as a workstation) on the network
●
Default IP: specify the IP address to use when the print server is unable to obtain an IP address
from the network when powered on or when reconfigured to use BOOTP or DHCP
●
Send DHCP requests: specify whether DHCP requests are transmitted when a legacy default
IP address or a default Auto IP is assigned
To configure the same network settings from the front panel, select the Connectivity menu icon
,
then Gigabit Ethernet > Modify configuration.
ENWW Configure network settings 23
Personal settings

HP Designjet Z5200 - PostScript Printer Specifications

General

Print Technology	Thermal Inkjet
Number of Inks	8
Memory	32 GB (virtual)
Hard Disk	160 GB
Line Accuracy	+/- 0.1%
Maximum Print Resolution	2400 x 1200 dpi
Ink Colors	Cyan, Magenta, Yellow, Light Cyan, Light Magenta, Light Gray
Media Sizes Supported	Up to 44 inches wide
Connectivity	Gigabit Ethernet (1000Base-T), Hi-Speed USB 2.0
Minimum Line Width	0.02 mm
Maximum Optical Density (Black)	2.5
Media Types	Bond and coated paper, photographic paper, self-adhesive and banner
Media Sizes Standard (Sheets)	A4, A3, A2, A1, A0
Media Sizes Standard (Rolls)	24 to 44-in rolls
Media Thickness	Up to 0.8 mm
Connectivity, Standard	Gigabit Ethernet (1000Base-T); Hi-Speed USB 2.0 certified; EIO Jetdirect accessory slot
Print Languages	Adobe PostScript 3, Adobe PDF 1.7, TIFF, JPEG, HP-GL/2, HP-RTL, CALS G4
Ink Types	Pigment-based
Operating Temperature Range	5 to 40°C
Dimensions (W x D x H)	1770 x 721 x 1050 mm