Carriage Flex Cables 337
Removal & Installation
Carriage Flex Cables
Removal
1. Remove the Right Cover
⇒
See page 264
.
2. Remove the Front Panel
⇒
See page 292
.
3. Remove the Primer Assembly
⇒
See page 294
.
4. Press the two side of the Carriage PCA Cover and
unclip from the Carriage Assembly.
5. Use a flat bladed screwdriver to release the ALL the
clips, securing the Carriage Flex Cables to the
Carriage Assembly, by pulling upwards.
6. Disconnect the ALL the Flex Cables from the Carriage
PCA.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...