HP Designjet Z6100 Printer series - Page 61

Continuable and Non-Continuable Error Codes 51
System Error Codes
• Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest
version.
•
Replace the Hard Disk Drive ⇒ Page 377.
•
Replace the Main PCA ⇒ Page 375.
• R
eplace the Memory Module ⇒ Page 373.
• Replace the Interconnect PCA ⇒ Page 357.
• Replace the Front Panel ⇒ Page 292.
• Replace the Sausalito PCI PCA⇒ Page 369.
System Error:
11:10
Problem Description:
Trailing Cable does not seem to be connected.
Corrective Action:
Try the following:
• Check that the Trailing Cable is not damaged.
• Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and to
the Sausalito PCI PCA.
• Replace the Sausalito PCI PCA ⇒ Page 369.
• Replace the Ink Supply Tubes and Trailing Cable ⇒ Page 312.
• Replace the Carriage PCA ⇒ Page 334.
System Error:
21:03
Problem Description:
Service Station servo shutdown.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• If the System Error continues, replace the Service Station ⇒ Page 300.
• Replace the PrintMech PCA ⇒ Page 384.
•
Replace the Interconnect PCA ⇒ Page 357.
NOTE: If the Ink Supply Tubes are to be replaced, the Ink Cartridges need to be checked
beforehand to see if they are capable of purging the new tubes, if they are not, new Ink
Cartridges must also be sent with the parts to be replaced. To check the Ink Cartridges go to ⇒
Page 129.
NOTE: Replace one part at a time and check if the error has cleared before replacing
another.