52 Chapter 2 System Error Codes
System Error Codes
System Error:
21:10
Problem Description:
Fault has been detect in the area of the Service Station.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. foam from the
printer’s packaging, screws, plastic parts, etc...) restricting the movement of the Service Station.
• If the System Error continues, replace the Service Station ⇒ Page 300.
System Error:
21:13
Problem Description:
Problem with the Service Station.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. screws, plastic
parts, etc...) restricting the movement of the Service Station.
• If the System Error continues, replace the Service Station ⇒ Page 300.
System Error:
23:10
Problem Description:
Problem with pressurization.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the APS cable is not damaged and is correctly connected to the PrintMech PCA.
• Replace the APS Assembly ⇒ Page 324.
• R
eplace the PrintMech PCA
⇒
Page 384.
• If the System Error continues, r
eplace the
Sausalito PCI
PCA
⇒
Page 369.
NOTE: Replace one part at a time and check if the error has cleared before replacing
another.
To Next Page
Loading...