HP Designjet Z6100 Printer series - Page 70

60 Chapter 2 System Error Codes
System Error Codes
• Open the Window and check for any visible obstacles restricting the movement of the Drive Roller. If
there is a wrinkled mass of media inside the paper path, lift the Pinchwheels (using the Media Lever)
and clear the obstruction.
• Replace the Media-Axis Motor ⇒ Page 349.
• If the System Error continues,
replace the PrintMech PCA ⇒ Page 384.
System Error:
41:10
Problem Description:
Electrical fault in paper motor.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Media-Axis Motor cable is not damaged and is correctly connected to the PrintMech
PCA.
• Replace the Media-Axis Motor ⇒ Page 349.
• If the System Error continues,
replace the PrintMech PCA ⇒ Page 384
System Error:
42:03
Problem Description:
Electrical current limit in carriage motor.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Open the Window and check for any visible obstacles restricting the movement of the Carriage
Assembly. If there is a wrinkled mass of media blocking the Carriage Assembly, then clear the
obstruction.
• Clean the Encoder Strip ⇒ Page 454.
• Replace the Scan-Axis Motor ⇒ Page 346.
• If the System Error continues,
replace the PrintMech PCA ⇒ Page 384.
System Error:
42:10
Problem Description:
Electrical fault in Carriage Motor or starting the Scan Axis or Homing Scan Axis.
Corrective Action:
Try the following: