HP Designjet Z6100 Printer series - Page 71

Continuable and Non-Continuable Error Codes 61
System Error Codes
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Scan-Axis Motor cable is not damaged and is correctly connected to the PrintMech
PCA.
• Clean the Encoder Strip using a lint free cloth dampened with tap water, then reset the counter
(Setup > Resets > Encoder cleaning) ⇒ See the instructions provided in the User Maintenance Kit
and ⇒Page 454
• Replace the Scan-Axis Motor ⇒ Page 346.
• If the System Error continues,
replace the PrintMech PCA ⇒ Page 384
System Error:
43:10
Problem Description:
Vacuum Fan Sstopped.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Vacuum Fan cbles are not damaged and are correctly connected to the Interconnect
PCA.
• Also check that the cables between the Interconnect PCA and the PrintMech PCA are not damaged
and are correctly connected.
• Replace the Interconnect PCA ⇒ Page 357.
• Replace the Vacuum Fan ⇒ Page 304.
• If the System Error continues,
replace the PrintMech PCA ⇒ Page 384
System Error:
44:10
Problem Description:
Problem with the Aerosol Fan.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Aerosol Fan cable is not damaged and is correctly connected to the Interconnect
PCA.
• Replace the Aerosol Fan ⇒ Page 300.
• If the System Error continues,
replace the Interconnect PCA ⇒ Page 357.
System Error:
44:11