2. A message appears on the Front Panel asking whether you would like to check the Formatter.
Press OK to continue with the test, or Cancel to exit.
3. The front panel displays the amount of memory installed. “Real memory size” is the real size
detected, and “Total memory size” shows the rounded memory size. Press OK to continue.
4. The front panel displays the name, type and size of all the partitions on the Hard Disk. Press OK to
continue.
5. The front panel displays the name, size and percentage used of the data and boot partitions on
the Hard Disk. Press OK to continue.
6. When the test is complete, OK is displayed on the front panel. Press OK to restart the printer.
Carriage Assembly test
The purpose of this test is to check the operation of the Carriage Assembly.
90 Chapter 4 Service tests and utilities ENWW
Service tests and
utilities
To Next Page
Loading...
