Acceptable values are:
●
Gain: between 0 and 5
●
DGain: between 0 and 15
●
Offset: between -80 and 80
If the results are acceptable, press OK. If the results are unacceptable, then press Cancel.
7. The printer performs the encoder homing test.
8. The front panel asks you to remove the paper. If you loaded a roll earlier, unload it manually.
Press OK when done.
9. Some further tests are performed, and the results displayed.
10. When the whole test has been completed successfully, the following message is displayed. Press
OK to restart the printer.
Electronics Module test
The purpose of this test is to diagnose a failure in the operation of the Formatter.
1. In the Diagnostics menu, scroll to Electronics Module and press OK.
ENWW
Entering the Service Tests menu
89
Service tests and
utilities
To Next Page
Loading...
