4. The printer will initialize some subsystems and move the carriage out of the service station. After
that it will ask you to select the printhead to prime. Use the Up/Down keys to change the
printhead number, and press OK to select.
While the printhead is being primed, a message saying Priming printhead will appear in the
front panel, indicating the number of the selected printhead. If any error occurs, a system error will
identify the part that has failed.
5. Once the printhead has been primed correctly, the message below appears. Press OK to turn off
the printer.
Aerosol Fan test
The purpose of this test is to check the operation of the Aerosol Fan(s).
1. In the Diagnostics menu, scroll to Service Station and press OK.
2. Within the Service Station submenu, select the Aerosol Fan test.
3. The test is automatic and needs no user intervention. After the test, the front panel shows that the
diagnostic result is OK, and asks you to press OK to continue. If there is any failure, an error
message will identify the part that failed.
ENWW
Entering the Service Tests menu
99
Service tests and
utilities
To Next Page
Loading...
