7. The front panel asks if you want to cap the printheads. Press OK to cap the service station or
Cancel to leave the printheads uncapped.
8. The front panel announces the result of the test. Press OK to turn off the printer.
TIP: If a system error message appears during the above procedure, see System error codes
on page 38.
Primer Motor test
The purpose of this test is to prime a specified printhead.
NOTE: If possible always perform this test before replacing the primer. If this test passes, do not
replace the primer.
1. In the Diagnostics menu, scroll to Service Station and press OK.
2. Within the Service Station submenu, select the Primer Motor test.
3. The printer will ask you to check that the printer covers, the doors and the pinch lever are closed,
and the printheads and cartridges correctly inserted. After checking those things, press OK.
98 Chapter 4 Service tests and utilities ENWW
Service tests and
utilities
To Next Page
Loading...
