8. When you have closed the Printhead Cover and the Windows, the printer begins to purge the
tubes.
9. When the tubes have been purged, the front panel asks you to open the Window.
10. When prompted by the front panel, check that all the Setup Printheads have some ink.
11. The front panel asks you to change the ink funnel and waste bottle, but you should ignore this
request. Continue the purge procedure, pressing OK to advance through the procedure, but
without changing any parts.
12. At the end of the procedure, the printer aligns the Printheads.
Reset Life Counters
The purpose of this Service Utility is to reset the internal life counters. There are two submenus that
allow you to:
●
Reset all the counters related to a Preventive Maintenance Kit (PMK).
●
Reset only the counters related to a specific replaced part.
NOTE: Reset the life counter of a part only after replacing that part.
1. In the Service Utilities submenu, scroll to Reset life counters and press OK.
2. You will be given an option either to reset the life counter for all the parts related to a Preventive
Maintenance Kit (PMK) or to reset the life counter for a particular part only.
108 Chapter 4 Service tests and utilities ENWW
Service tests and
utilities
To Next Page
Loading...
