2. Remove two T-15 screws and four T-20 screws that secure the Left Trim.
3. Carefully remove the Left Trim from the printer.
Top Cover (42-inch)
Removal
WARNING! Switch off the printer and remove the power cable.
NOTE: Throughout this section the graphics actually show the HP Designjet 4000 printer series but
the steps of the procedure are identical for the HP Designjet Z6000 printer series.ˋ
1. Remove the Right Cover See Right Cover on page 216.
2. Remove the Left Cover
See Left Cover on page 222.
224 Chapter 8 Removal and installation ENWW
Removal and
installation
To Next Page
Loading...
