8. Slide the Drop Detector forward so you can release it from the Service Station.
9. Remove the Drop Detector from the printer.
NOTE: After installing the new Drop Detector, make sure you perform the following Service
Calibration:
●
Drop Detector calibration
Drop Detector calibration on page 129.
Ink Supply Tubes and Trailing Cable
Removal
WARNING! Switch off the printer and remove the power cable.
CAUTION: You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes and
Trailing Cable at the same time. If both parts need to replaced, you MUST first replace one part and
then power ON the printer until it completely initializes. Then you can power OFF the printer and
replace the other part.
1. Remove the Window:
●
For the 42-inch
See Window (42-inch) on page 213.
●
For the 60-inch
See Window (60-inch) on page 215.
2. Remove the Right Cover
See Right Cover on page 216.
3. Remove the Left Cover
See Left Cover on page 222.
ENWW
Disassembly order
265
Removal and
installation
To Next Page
Loading...
