10. Remove two T-20 screws (Type B) that secure the Media-Axis Motor Bracket.
11. Remove the Media-Axis Motor from the printer.
Installation
When reinstalling the parts, make sure you apply the grease (included with the support part) to the
gears.
After installing the new Media-Axis Motor, make sure you perform paper-advance calibration
Paper-
advance calibration on page 127.
Optical Media Advance Sensor (OMAS)
Removal
WARNING! Switch off the printer and remove the power cable.
NOTE: The removal procedure differs depending on the printer model, 42-inch or 60-inch.
1. 42-inch model ONLY
Open the Rear Door. and go to step 4.
2. 60-inch model ONLY
Remove the Left Cover
See Left Cover on page 222.
3. Remove the Rear Door
See Rear Door (60-inch) on page 237.
316 Chapter 8 Removal and installation ENWW
Removal and
installation
To Next Page
Loading...
