4. Release the clips on the left- and right-hand sides of the Front Platen.
5. Pull out the right-hand side of the Front Platen.
6. Carefully slide the Front Platen to the right and then remove from the printer.
NOTE: If a new Front Platen is to be installed, make sure that you first remove all Media Deflectors
(see
Media Deflector on page 360) from the old Front Platen and install them on the new Front Platen.
Print Platen
Removal
362 Chapter 8 Removal and installation ENWW
Removal and
installation
To Next Page
Loading...
