SE 50:14
Cause: Firmware version mismatch between the OMAS Controller Card and Hard Disk Drive
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the printer has the latest firmware version. If not, update the firmware to the latest
version.
●
Replace the OMAS Controller Card
OMAS Controller Card on page 326.
SE 50.2:10
Cause: OMAS Controller Card communication failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the printer has the latest firmware version. If not, update the firmware to the latest
version.
●
Replace the OMAS Controller Card
OMAS Controller Card on page 326.
SE 50.3:11
Cause: Main PCA to OMAS Controller cable does not seem to be connected
Solution: Try the following:
●
Check that the Main PCA to OMAS Controller cable is not damaged.
●
Check that the Main PCA to OMAS Controller cable is correctly connected to the Main PCA and
the OMAS Controller Card.
SE 51:10
Cause: Error detected in the Window Position Sensor
Solution: Try the following:
●
Check that the Window Position Sensor cable is not damaged and is correctly connected to the
Interconnect PCA.
●
Replace the Window Position Sensor
Window Position Sensor on page 242.
SE 51.1:10
Cause: Error detected in the Maintenance Cartridge Door Sensor (Service Station Door Sensor)
ENWW
Continuable and non-continuable error codes
61
System error codes
To Next Page
Loading...
