Solution: Try the following:
●
Check that the sensor cable is not damaged and is correctly connected to the Interconnect PCA.
●
Replace the Maintenance Cartridge Door Sensor
Maintenance Cartridge Door Sensor
on page 377.
SE 52:10
Cause: Drop Detector switch On/Off failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Drop Detector cable is not damaged and is correctly connected to the Service
Station cable.
●
Check that the Service Station cable is not damaged and is correctly connected to the Interconnect
PCA.
●
Replace the Drop Detector
Drop Detector on page 262.
SE 53:10
Cause: Media Sensor error
Solution: Try the following:
●
Check that the Media Sensor cable is not damaged and is connected correctly to the Interconnect
PCA.
●
Replace the Media Sensor
Media Sensor on page 378.
SE 53.1:11
Cause: Media Sensor cable does not seem to be connected
Solution: Try the following:
●
Check that the Media Sensor cable is not damaged.
●
Check that the Media Sensor cable is correctly connected to the Interconnect PCA.
SE 54:10
Cause: Media Lever Sensor error
Solution: Try the following:
●
Check that the Media Lever Sensor cable is not damaged and is connected correctly to the
Interconnect PCA.
●
Replace the Media Lever Sensor
Media Lever Sensor on page 386.
62 Chapter 2 System error codes ENWW
System error codes
To Next Page
Loading...
