SE 55:10
Cause: Line Sensor communication failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Replace the Line Sensor
Line Sensor Assembly on page 353.
SE 56:01
Cause: Incorrect readings from paper encoder
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Perform Paper Drive diagnostics.
●
Replace the Encoder Disc and Sensor
Encoder Disc and Sensor on page 380.
SE 56:10
Cause: Paper Encoder calibration failed
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Perform Paper Drive diagnostics.
●
Replace the Encoder Disc and Sensor
Encoder Disc and Sensor on page 380.
SE 58:01
Cause: Embedded PhotoSpectrometer (ESP) shutter error
Solution: Execute the ESP Shutter Diagnostic Test.
SE 58:10
Cause: Embedded PhotoSpectrometer (ESP) failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the ESP is installed in the Carriage.
●
Check that the ESP is correctly installed and screwed into place.
●
Check that the ESP cable is not damaged.
●
Check that the ESP cable is correctly connected to the Carriage PCA.
ENWW
Continuable and non-continuable error codes
63
System error codes
To Next Page
Loading...
