HP DF840P1 - Set Schedule; Disable Schedule; Run the Schedule; Run Schedule from Slideshow

14
SetSchedule
You can schedule the DPF to automatically go into a “stand-by” mode and resume operation according to your weekly
schedule. For example, if you have your DPF on your desk at work, you may want to display the calendar/clock or
play a slideshow from 8:30am to 5:30pm every weekday, and then set the DPF to remain in stand-by mode
throughout the weekend. The following Monday morning, the DPF would resume operation at 8:30am.
1. On the
CALENDAR/CLOCK screen, press .
2. Select
SetSchedule.
3. Use to move between the fields and to change the field values in WeekdaysOn/Off.
4. To set the
Weekends On/Off, select the EnableWeekendsSchedule button, and then use
to access the
settings.
5. Use
to move between the fields and
to change the field values in
WeekendsOn/Off.
6. When correct times are set, select
Done to return to the previous screen.
DisableSchedule
After the schedule has been enabled (per above instructions), you can disable the schedule whenever desired.
1. On the
CALENDAR/CLOCK screen, press .
2. Select
SetSchedule, and then select the EnableWeekdaysSchedule or EnableWeekendsSchedule button.
The time fields will display
OFF.
3. Select
Done.
RuntheSchedule
After the schedule times have been set (per above instructions), you will use the RunSchedulefunction whenever
you want the schedule to take effect.
There are two methods for running the schedule, either from a slideshow or from the
CALENDAR/CLOCK screen.
CAUTION: After you select the
RunSchedule function, any user intervention will cancel the activation (i.e.,
pressing remote or control button, powering off) and the schedule will not take effect until you select
this function again to re-activate.
RunSchedulefromSlideshow
1. Start a slideshow, and then press
when the
RunSchedule button appears (approx 10 seconds). A
small timer clock will appear indicating the schedule is active. To run the schedule when the
RunSchedule
button is no longer displayed, restart your slideshow and then press
when the
RunSchedule button
appears again.
2. The DPF will go into stand-by mode according to the schedule, and when it resumes operation, the
slideshow will again begin
to play.
RunSchedulefromCALENDAR/CLOCKScreen
1. On the CALENDAR/CLOCK screen, press .
2. Select
RunSchedule. A small timer clock will appear indicating the schedule is active, and then the DPF will
operate according to the set schedule.
3. The DPF will go into stand-by mode according to the schedule, and when it resumes operation, the
Calendar/Clock screen will again be displayed.