HP DF840P1 - Set Sleep Mode; Set Language; Reset to Factory Defaults

16
ConnectDPFtoMacintoshComputer
1. Use a USB cable to connect the DPF to your Macintosh computer.
2. Macintosh will recognize the DPF as an external storage device.
3. Drag and drop files between the two devices as you normally move files.
DisconnectDPFfromMacintoshComputer
1. To safely disconnect the DPF from your Macintosh, select DPF’s icon on your desktop and press Command‐e to
eject the disk.
2. When the icon is no longer on the desktop, it is safe to unplug the USB cable.
Set SleepMode
The DPF will stay on until you power it off, however, to save power you can set it to automatically go into a sleep mode
when left idle for a specific amount of time.
1. On the
HOME screen, press
to display the
Setup Menu.
2. Select
Set Sleep Mode, and then select the desired setting.
OFF(default)=Powersaveris‘disabled’;DPFwillremainonuntilyoupoweritofforchangethesleepmodesetting
2/4/8Hours=TheDPFwillautomaticallygointosleepmodewhenleftidlethespecifiedamountoftime
3. Select Done.
Set Language
Depending on model, this DPF may include multiple languages for the user interface display.
1. On the
HOME screen, press
to display the
Setup Menu.
2. Select
Set Language, and then select the desired language.
Reset to Factory Defaults
If you have changed function settings, using this feature will restore all settings to the factory pre-set defaults.
1. On the
HOME screen, press
to display the
Setup Menu.
2. Select
ResettoFactoryDefaults, and then select Yes to reset, or No to leave current settings.
3. Press
to return to the
HOME screen.