Chapter 4 Remote Interface Reference
An Introduction to the SCPI Language
116
Querying Parameter Settings
<RX#FDQ#TXHU\#WKH#YDOXH#RI#PRVW#SDUDPHWHUV#E\#DGGLQJ#D#TXHV WLRQ#PDUN##+",#WR#
WKH#FRPPDQG1#)RU#H[DPSOH/#WKH#IROORZLQJ#FRPPDQG##VHWV#WKH#RXWSXW#FXUUHQW#
WR#8#DPSV=
#####©©CURR 5ªª
<RX#FDQ#TXHU\#WKH#YDOXH#E\#H[HFXWLQJ=
#####©©CURR?ªª
<RX#FDQ#DOVR#TXHU\#WKH#PLQLPXP#RU#PD[LPXP#YDOXH#DOORZHG#ZLWK#WKH##SUHVHQW#
IXQFWLRQ#DV#IROORZV=
#####©©CURR? MAXªª
#####©©CURR? MINªª
Caution If you send two query commands without reading the response from the first, and then
attempt to read the second response, you may receive some data from the first response
followed by the complete second response. To avoid this, do not send a query
command without reading the response. When you cannot avoid this situation, send
a device clear before sending the second query command.
SCPI Command Terminators
$#FRPPDQG#VWULQJ#VHQW#WR#WKH#SRZHU#VXSSO\#PXVW#WHUPLQDWH#ZLWK#D#?QHZ#OLQH!#
FKDUDFWHU1#7KH#,(((07;;#(2,#+HQG0RU0LGHQWLI\,#PHVVDJH#LV#LQWHUSUHWHG#DV#D#
?QHZ#OLQH!#FKDUDFWHU#DQG#FDQ#EH#XVHG#WR#WHUPLQDWH#D#FRPPDQG#VWULQJ#LQ#SODFH#
RI#D#?QHZ#OLQH!#FKDUDFWHU1#$#?FDUULDJH#UHWXUQ!#IROORZHG#E\#D#?QHZ#OLQH!#LV#
DOVR#DFFHSWHG1#&RPPDQG#VWULQJ#WHUPLQDWLRQ#ZLOO#DOZD\V#UHVHW#WKH#FXUUHQW#6&3,#
FRPPDQG#SDWK#WR#WKH#URRW#OHYHO1#7KH#?QHZ#OLQH!#FKDUDFWHU#KDV#WKH#$6&,,#
GHFLPDO#FRGH#RI#431#
IEEE-488.2 Common Commands
7KH#,(((07;;15#VWDQGDUG#GHILQHV#D#VHW#RI#FRPPRQ#FRPPDQGV#WKDW#SHUIRUP#
IXQFWLRQV#OLNH#UHVHW/#VHOI0WHVW/#DQG#VWDWXV#RSHUDWLRQV1#&RPPRQ#FRPPDQGV#
DOZD\V#EHJLQ#ZLWK#DQ#DVWHULVN#+#-#,/#DUH#IRXU#WR#ILYH#FKDUDFWHUV#LQ#OHQJWK/#DQG#
PD\#LQFOXGH#RQH#RU#PRUH#SDUDPHWHUV1#7KH#FRPPDQG#NH\ZRUG#LV#VHSDUDWHG#
IURP#WKH#ILUVW#SDUDPHWHU#E\#D#EODQN#VSDFH1#8VH#D#VHPLFRORQ#+#>#,#WR#VHSDUDWH#
PXOWLSOH#FRPPDQGV#DV#VKRZQ#EHORZ=
©©*RST; *CLS; *ESE 32; *OPC?¨
To Next Page
Loading...
