Docking connector board
Description Spare part number
Docking connector board
NOTE: The docking connector board spare part kit does not include the docking connector
board cable. The docking connector board cable is included in the Slate Cable Kit, spare part number
793721-001.
793731-001
Before removing the docking connector board, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see Display panel assembly on page 35).
5. Remove the battery (see Battery on page 39).
Remove the docking connector board:
1. Remove the following screws:
(1) Four Phillips PM1.9×2.5 screws
(2) One Phillips PM1.5×2.3 screw
(3) One Phillips PM1.5×3.5 screw
2. Remove the left alignment post connector bracket (4).
3. Remove the docking connector board bracket (5).
Docking connector board 49
To Next Page
Loading...
