Not all configuration components are available in all regions/countries.
c04895999 — DA – 15477 — Worldwide — Version 16 – March 22, 2017
DP & HDMI Color Depth
Support
The following color depths are supported
8 bits per color
The Output interface (Display Port Multi-
Stream Transport, DP MST) has the ability
to support dual display mode – splitting
the video stream is based on external HW
(with monitors that can support it, a daisy
chain approach can be used to support
dual display mode)
Multiple Display Stream
Support (MST)
The following dual display mode via MST
is supported
2 x (1280x720)
2 x (1920x1080)
2 x (1920x1200)
1920x1080 plus 1920x1200
Audio Pass-Through
Support
Support for all relevant Audio formats in
Support for all relevant Audio formats in
Pass-Through mode as defined in the
WDE specification. LPCM (uncompressed
and uncompounded), 2-8 channels,
32KHz – 192KHz, up to 24 bits per sample
(dependent on the number of channels)
Independent Digital Audio
Out Interface (Sink)
Support for an independent digital Audio
Out sink interface, operational upon
insertion of an audio peripheral, and not
dependent on monitor state
(On/Off/Powered-Off)
4 x I2S Interfaces
Multiplexed with
S/PDIF Interface
Selection of Independent
Audio Out Interface
Selection of output interface (I
2
S or
SPDIF) and on-board audio device
capabilities is configurable on a system
basis through module Flash
Configuration.
AUX/DDC Channel Interface
AUX (DP) / DDC (HDMI) channel is
supported.
Note: FAUX – fast AUX (~7000Mb) is not
required.
Chosen resolution, frame
rate, color space, audio
capabilities
WDE will inform the host graphics of the
best resolution , frame rate, color space
and audio capabilities based on
Native/Supported monitor
resolutions
Module Core Capabilities
Power consumption considerations
Link status(physical layer rate and
other services)
Plug and Play through hot plug detection
is not supported
Wireless Serial Extension (WSE)
for support of USB data flow over
wireless link
USB PAL (WSE) version 1.2 (June 2013)