NFC module
Description Spare part number
NFC (Near Field Communication) module 739578-001
Before removing the NFC module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Bottom cover (see
Bottom cover on page 35)
5. Remove the battery (see
Battery on page 41).
Remove the NFC module:
1. Disconnect the NFC antenna (1) and the system board cable (2) from the NFC module..
2. Slide the module away from the ForcePad (3), and the lift it from the computer (4).
NOTE: The NFC module cable and NFC antenna are available in the Cable Kit, spare part number
739564-001.
Reverse the removal procedures to install the NFC module.
Component replacement procedures 55
To Next Page
Loading...
