2. Remove the seven rubber screw covers from the screws outside of the service cover.
NOTE: The eight screws outside of the service cover also have rubber covers.
3. Remove the 16 Torx T8M2.5×5.0 screws that secure the base enclosure to the computer.
4. Remove the Phillips PM2.0×8.0 screw (1) near the media card reader and the six Phillips PM2.0×5.0
broadhead screws (2) inside the battery bay that secure the base enclosure to the computer.
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
