7. Remove the keyboard (see Keyboard on page 65).
8. Remove the top cover (see
Top cover on page 81).
Remove the audio/USB 2.0 board:
1. Position the computer right-side up with the front toward you.
2. Disconnect the speaker cable (1) from the audio/USB 2.0 board.
3. Remove the three Phillips M2.5x3.0 screws (2) that secure the audio/USB 2.0 board to the base
enclosure.
4. Lift the left edge (3) of the audio/USB 2.0 board to disconnect it from the system board.
5. Remove the audio/USB 2.0 board (4) at an angle to the left from the base enclosure.
Reverse this procedure to install the audio/USB 2.0 board.
Component replacement procedures 97
To Next Page
Loading...
